Declaration Of Conformity - McCulloch M4620 Manual De Instrucciones

TROUBLESHOOTING TABLE
WARNING:
Always stop unit and disconnect spark plug before performing all of
the recommended remedies below except remedies that require operation of the unit.
TROUBLE CAUSE
1. Ignition switch off.
Engine will not
2. Engine flooded.
start or will run
only a few
3. Fuel tank empty.
seconds after
4. Spark plug not firing.
starting.
5. Fuel not reaching
1. Idle speed requires
Engine will
not idle
2. Carburetor requires
properly.
Engine will not 1. Air filter dirty.
accelerate, 2. Spark plug fouled.
lacks power, 3. Chain brake engaged.
or dies under 4. Carburetor requires
a load.
Engine 1. Too much oil mixed with
smokes
excessively.
1. Idle speed requires
Chain moves
at idle speed.
2. Clutch requires repair.

DECLARATION OF CONFORMITY

EC Declaration of Conformity (Only applies to Europe)
We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46- -36- -146500, as authorised
representative in the Community, declare that the chain saw for forest service model
McCulloch M4620 P---600 with serial numbers dating from 2009 and onwards (the year is
clearly stated on the rating plate, followed by the serial number), comply with the requirements
of the COUNCIL'S DIRECTIVES:
of 17 May 2006 "relating to machinery" 2006/42/EC;
of 15 December 2004 "relating to electromagnetic compatibility" 2004/108/EC, and applicable
supplements; and
of 8 May 2000 "relating to the noise emissions in the environment" in accordance with Annex
V of 2000/14/EC. For information relating to noise emissions, see Technical data section.
The following standards have been applied: EN ISO 12100-1/A1:2009, EN ISO
12100-2/A1:2009, CISPR 12:2007, EN ISO 11681-1:2008.
Notified body, 0404, SMP, The Swedish Machinery Testing Institute, Fyrisborgsgatan 3
S- -754 50 Uppsala, Sweden, has carried out EC type examination in accordance with the
machinery directive's (2006/42/EC) article 12, point 3b. The certificates for EC type
examination in accordance with annex IX, have the numbers: 0404/09/2038.
The supplied chain saw conforms to the example that underwent EC type examination.
09- -11- -01
carburetor.
adjustment.
adjustment.
adjustment.
gasoline.
adjustment.
Ronnie E. Goldman, Director of Engineering
Authorized representative for Husqvarna AB and
responsible for technical documentation
REMEDY
1. Move ignition switch to ON.
2. See "Difficult Starting" in
Operation Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
1. See "Carburetor Adjustment" in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
1. Clean or replace air filter.
2. Clean or replace plug and regap.
3. Disengage chain brake.
4. Contact an authorized service dealer.
1. Empty fuel tank and refill with
correct fuel mixture.
1. See "Carburetor Adjustment" in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
16