Is there a problem?
Little or no steam.
The soleplate is scratched or
worn.
If you are not able to determine the cause of a fault, contact an authorized after-sales service center.
Never dismantle the appliance.
Possible causes
Steam adjustment control set
to zero.
Scale build-up.
Iron used on "dry" for
excessive period of time
Tank empty.
The iron has been placed
face down on a metal iron
rest.
Iron dropped or knocked.
Solutions
Set the cursor to between
2 and 8.
Remove the anti-clogging
valve and soak it in white
vinegar or pure lemon juice.
See maintenance section.
Clean the anti-clogging
valve.
Fill the tank with tap water.
Always place your iron on its
heel, in a stable position.
Consult an approved service
center.