U S E A N D M A I N T E N A N C E; Maintenance And Cleaning - Sunrise Medical JAY Fit Manual Del Usuario

E N G L I S H
WARNING!
• The owner of this equipment is responsible for making
sure that it has been set up and adjusted by an
authorised dealer under the advice of a healthcare
professional.
• The back and hardware may require periodic safety and
function checks.
• Adjustments should be performed by your authorised
dealer.
• Always use parts and/or accessories that have been
recommended or approved by Sunrise Medical.
A. MAINTENANCE AND CLEANING
• Proper maintenance and cleaning will improve
performance and extend the useful life of your
equipment.
• Clean your equipment regularly. This will help you find
loose or worn parts and make your equipment easier
to use. You will need a mild detergent solution and
cleaning rags.
• If discovered, have loose, worn, bent or damaged parts
replaced before using the back.
B. CRITICAL SAFETY CHECKS
Fasteners:
• Sunrise Medical recommends that all fasteners be
checked for wear, such as loose bolts or broken
components every 6 months.
• Loose fasteners should be re-tightened according to the
installation instructions.
• Contact your authorised dealer immediately to replace
any components.
• Do not continue to use the system after identifying
loose or broken components.
Jay Fit Back

U S E A N D M A I N T E N A N C E

C. EASY CLEANING (FIG.6.0)
1. Back cover
a. Remove the cover from back-shell by detaching the
Velcro®.
b. Unzip the zipper on the bottom of the cover.
c. Remove the foam and turn the cover inside out.
d. Zip the cover closed to avoid snagging.
e. Machine wash in warm water (50°C).
f. Drip and tumble dry in on Low Heat.
CAUTION!
• Do not dry clean covers or use industrial washers or
dryers to clean covers.
• Do not steam autoclave.
• Do not bleach.
• Laundry care symbol definitions are shown.
2. Back shell
The back-shell should be wiped clean with soap and
water on a regular basis to prevent build up of dirt and
grime.
3. Positioning components
a. Remove the components one at a time, noting the
placement for re-assembly.
b. Positioning components can be wiped clean with
soap and water.
c. DO NOT immerse positioning components
underwater.
Fig.6.0
Laundry Care Symbols
Machine wash in warm water (50° C)
Only non-chlorine bleach, when needed
Drip dry
Do not iron
Do not dry clean
12
Rev.D