Sunrise Medical JAY Fit Manual Del Usuario página 19

E N G L I S H
N. HEIGHT ADJUSTABLE QUICK MOUNT ATTACHING
SEAT HARDWARE
To Remove the Seat:
NOTE: Fig.20.0 viewed from underneath, Fig.21.0 and
Fig.22.0 are viewed from the side.
1. With the chair unoccupied, reach under the front of the
seat and pull the quick release cable (P) forward.
2. While holding the release cable forward, lift the front of
the seat from the latch mechanism assembly (O) and
slide the rear brackets (Q) forward from the rear receiver
clamp assemblies (R) on the chair.
To Attach the Seat:
1. Holding the seat as shown in Fig.21.0, slide the rear
brackets (Q) into the rear receiver clamp assemblies
(R).
2. Centre the latch mechanism assemblies onto the front
receiver studs (S) and press down until locked.
3. Insert the safety lock pin (T) into the latch mechanism
assembly .
NOTE: For a wheelchair with the Sunrise Transit Option,
your system will have two lock pins. insert the safety lock
pins into the latch mechanism assemblies (S) on both sides
of the seat during transit.
WARNING!
Risk of injuries and how to avoid them:
Improper attachment of the seat may cause the seat to
unintentionally disconnect during use, potentially causing the
rider to fall.
To avoid the risk:
• It is vital to follow all instructions when re-attaching the
seat.
• Before seating the rider, ensure that the seat is locked in
place.
• Return to your supplier for adjustment if the latch
mechanism assemblies do not centre and lock on the
front receiver studs with ease.
Jay Fit Back
I N S TA L L AT I O N A N D A D J U S T M E N T
Fig.20.0
O
Q
Fig.21.0
R
REAR
Fig.22.0
19
P
S
T
S
Rev.D