Sunrise Medical JAY Fit Manual Del Usuario página 15

E N G L I S H
D. BOTTOM WIDTH ADJUSTMENT
Remove the Jay Fit Back from the wheelchair. Loosen
the lower back bracket nuts and slide the brackets so that
the stud nuts (E) fit into the lower receiver assemblies (B,
previous page). Adjust the brackets evenly on both sides
and lightly tighten the bracket nuts.
E. TOP WIDTH ADJUSTMENT
Remove the Jay Fit Back from the wheelchair. Loosen the
upper back bracket nuts (D) and slide the brackets so that
the upper back hooks match the wheelchair post width.
Adjust the brackets evenly on both sides and tighten the
bracket nuts. Replace the back in the wheelchair.
F. ASSESS AND ADJUST BACK HEIGHT
Position the user's hips to the back of the wheelchair. The
top of the back should be located approximately at the top of
the shoulder. To adjust the height of the back, loosen screw
(F) and slide lower receiver assemblies up or down. Once
proper height is determined, tighten brackets firmly.
HINT: If you encounter interference with the lower back
brackets, simply loosen the brackets at the point of
attachment to the back, and move up or down in the track
as needed.
G. ASSESS AND ADJUST SEAT DEPTH AND BACK
ANGLE
1. To adjust seat depth, loosen the fasteners for the top
hook and lower receiver stud nut on both sides (G). Slide
the back on the bracket nuts to the desired depth.
2. To add recline, slide the top hooks forward or back to
find the desired angle of recline. Recline may also be
obtained by adjusting the placement of the stud nut on
the lower bracket.
3. Adjust the top hooks and lower receiver stud nut evenly
on both sides and tighten the fasteners.
Jay Fit Back
I N S TA L L AT I O N A N D A D J U S T M E N T
Fig.12.0
Fig.13.0
F
Fig.14.0
G
D
Upper Back Brackets.
Lower Back Brackets.
E
Adjustment Screw.
F
Seat Depth and Angle Adjustement.
G
15
D
E
Rev.D