Sunrise Medical JAY Fit Manual Del Usuario página 16

E N G L I S H
H. INSTALL THE TOP QUICK RELEASE QUARTER TURN
BRACKET HARDWARE
Attach one top quick release quarter turn bracket (H) to
each upright post of the wheelchair.
1. The top quick release quarter turn bracket is designed to
fit on 1.6 cm, 1.9 cm, 2.2 cm, and 2.5 cm (5/8", 3/4", 7/8"
and 1") diameter back post tubing. (The bracket comes
assembled to attach to 2.2 cm or 2.5 cm tubing.) Check
Fig.15.0 to determine which strap hole is appropriate for
the installation. Wrap the strap around the wheelchair
post. Screw (K) may have to be loosened to align the
strap hole with the barrel nut located inside the bracket
body. Place a washer on screw (J) and insert the screw
through the appropriate hole in the strap.
2. Tighten screw (J) into the barrel nut through the side
of the bracket body. Tighten the opposite screw if
necessary.
3. Snap the screw caps over both screw heads.
4. To adjust the height of the bracket, loosen screw "A"
until the bracket slides freely on the back post. Once
the proper height of the back is determined, tighten the
screw. All future adjustments of the back height are done
with screw (K).
5. Always turn the quick-release quarter turn bracket to the
"DOWN" position to secure the top hook in place.
NOTE: If you encounter interference with the top back
brackets, simply loosen the brackets at the point of
attachment to the back, and move up or down in the track
as needed.
WARNING!
• The top quick-release quarter turn brackets must be
in their downward position when the back is in use.
Improper use may cause the back to unexpectedly
detach from the wheelchair.
• Do not use the Jay Fit Back to push or lift the wheelchair.
Improper use may cause the back to unexpectedly
detach from the wheelchair.
Jay Fit Back
I N S TA L L AT I O N A N D A D J U S T M E N T
Fig.15.0
H
J
Fig.16.0
H
H Quick Release Quarter Turn Bracket.
I Wheelchair Post.
Fixing Screw.
J
Adjustment Screw.
K
16
I
K
Rev.D