Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Incorrect operation is understood as:
• The buckle clasps are notably slow to release when
the red button is pressed.
• The buckle clasps cannot be inserted (they fall out
when they are inserted into the buckle).
• The buckle clasps come together without making a
click.
• It becomes difficult to insert the clasps into the buckle
(resistance is felt).
• The buckle only opens when forced.
Solution
Clean the harness buckle so that it works properly.
3.3. Cleaning the harness buckle
1. open the buckle (press the red button).
2. Hold the metal plate
(24)
from below in a vertical
position (fig.5).
3. Slide the metal plate
(24)
along the slot.
4. Remove the buckle (7).
5. Steep the buckle
(7)
in hot water and neutral liquid
detergent for at least one hour. Rinse and dry it.
3.4. Removing the 5-point harness
1. Loosen the harness straps by pulling them at the
point where they cover the chest while pressing the
harness adjustment button
(13)
(fig.2).
2. Locate the harness strap connector
(18)
and unclip
the harness straps, freeing them from the connector,
then remove them by pulling them from the front of
38
the seat (fig. 3 and 4).
3. Free the shoulder protectors
(3)
by unfastening them
from the connector that joins them (located at the back
of the seat) or, in the event they are joined without
a connector, by passing them directly through the
corresponding holes in the seat.
(13)
Harness
fig. 2
adjustment
button.
13
(17)
harness
fig. 3
strap
connector.
(18)
Shoulder
pads
18
conector
BNO FIX 0+123
18
17
4. Lift the fabric cover and keep the harness straps folded
in the corresponding seat hollow so that they do not
disturb the child. Replace the cover in its place.
5. Turn the seat over and, from the back, free the belt
buckle
(7)
by passing the retention plate
the slot in the seat (fig. 5).
6. Remove the belt buckle and save it in the storage bag.
7. Take off the harness straps by pulling them out of the
seat.
3.5. Removing the cover
A) Headrest.
1. Adjust the headrest to its highest position.
17
www.babyqs.com
fig. 4
2. First remove the part of the cover that includes the
safety belt guide
(2)
followed by the remainder of the
headrest cover.
B) To remove the 5-point harness, see point 3.4.
Remove the back and base covers.
(24)
through
3.6. Putting the cover back on
Follow the same steps in reverse order.
IMPORTANT! never use the safety seat following the
installation instructions described in point 5 without
having a correctly installed buckle. make sure the
metallic plate
(24)
is properly secured.
24
39
Publicidad
Tabla de contenido
