Programming Instructions; Key Function - Fracarro FIL 10 Instrucciones De Funcionamiento

For the correct programming of the FIL headend, proceed as follows:
1. Connect the power supply to the unit and to the mains
2. Wait for the headend start-up (the FRACARRO logo will appear on the display) Wait for the headend start-up (the FRACARRO logo will appear on the display)
3. enter the menu by pressing
4. defi ne each cluster without considering their gain level. See paragraph "5.3.1 Programming the cluster
UHF input" or "6. Programming software".
5. Perform the automatic self-alignment of all gains by using the SELF-ALIGNMENT function. See para-
graph "5.4 Self-alignment menu".
As an alternative to point 4, use a USB pen to load a confi guration created by the programming software
(see chapter 6) or a confi guration that has been previously saved from a product of the FRPRO series (see
paragraph 5.2.3).
4.1 DEFAULT CONFIGURATION
Installer code
Language
Remote power
Gain level for UHF inputs (dB)
Gain level for B.III+DAB input (dB)
Clusters gain level (dB)
Clusters-input combination
Clusters status
The FIL unit can be programmed through the built-in keypad or through the PC software FRPRO.
Further information about the PC software can be found on chapter 6 "Programming software".
Use the keypad and the display that the product is equipped with in order to program and display the unit Use the keypad and the display that the product is equipped with in order to program and display the unit
status. To enter the programming menu, press
To change the language of the menu, enter the "CONTROL UNIT – LANGUAGE" menu and select the lan- To change the language of the menu, enter the "CONTROL UNIT – LANGUAGE" menu and select the lan-
guage pressing .
For all programming operations and for interpreting the programming menus displayed in the following fl ow-
charts, refer to the following legend:
Keypad
or
✓
➤
✗
or
➤
9
0
......
WXYZ
S
NOTE: The headend confi guration is automatically saved once you exit the menu, even if you don't press NOTE: The headend confi guration is automatically saved once you exit the menu, even if you don't press
the button.
4. OPERATION INSTRUCTIONS
and enter the user code (default 1234)
Menu

5. PROGRAMMING INSTRUCTIONS

To confi rm a value or to select a menu/submenu
Default parameters
Flexible and programmable matrix
and enter the PIN code (default 1234).

Key Function

To cancel a value or exit a menu
To scroll through menu items
To increment/decrement a value
To enter values
To save settings
29
1234
Italian
OFF
20 (max)
20 (max)
20 (max)
OFF