Fracarro FIL 10 Instrucciones De Funcionamiento página 30

Enter PIN
Setting the input
parameters and cluster
Automatic settings of gain
Power supply ON/OFF on
Note: UHF3 input is not available on FIL 06.
From the main menu, 4 sub-menu are available:
CONTROL UNIT settings: it includes language settings, PIN management, configuration loading/saving
from the USB pen drive and resetting the unit to the factory settings.
INPUT settings: the main functions of this menu are the definition and programming of UHF clusters and
the setting of B.III+DAB input gain.
SELF-ALIGNMENT settings: it starts the self-alignment of all gains in order to automatically equalize the
clusters, guaranteeing the best noise figure and the maximum output level.
REMOTE POWER settings: the function of this menu is to activate the remote power on the UHF inputs
(independently).
5.1 MAIN MENU
Setting the headend
parameters
SETTINGS
FRACARRO
CONTROL UNIT
FIL10
Enter code
SETTINGS
INPUT
SETTINGS
SELF-ALIGNING
self-aligment
SETTINGS
the UHF inputs
REMOTE POWER
LANGUAGE
PIN
LCD CONTRAST
USB STORAGE
SERIAL SPEED
SOFTWARE VERSION
DEFAULT RESET
UHF 1
UHF 2
UHF 3
B.III
START-UP
TELE 12V/24V
UHF 1 YES/NO
UHF 2 YES/NO
UHF 3 YES/NO
30
31
see page
33
see page
35
see page
36
see page