Fracarro FIL 10 Instrucciones De Funcionamiento página 37

Software FRPRO can be downloaded from www.fracarro.com.
Minimum requirements for the system:
• Dotnet Framework v.2 or later
• Windows XP Service Pack 2 or later (Windows Vista and 7)
Using the FRPRO software, you can create a configuration of the clusters (initial channel and end channel,
channel type, cluster level, etc.) and of the other inputs by working from the computer. The configuration file
will be saved in a USB pen drive and then it will be loaded into the FIL unit and/or a copy of the configuration
can be saved onto the hard disk.
Use the Print function to print the configuration.
Note:
To program the FIL, you can neglect the settings relevant to the input and output levels as the FIL unit is
equipped with the self-alignment function that automatically sets these gain values in order to equalize the
level of all clusters by optimizing the noise figure and the output level of all signals. See paragraph 5.4.
After launching the FRPRO software, set the product model that you want to program. Select the "File - New"
menu and choose the product model you want to program from the pop-up window.
The following is a description of the FRPRO software window:
Led di indicazione di abilitazione della
LED to show that the voltage 12V or
tensione 12V o 24V per ingresso UHF
24V is enabled for the UHF input
B.III+DAB input gain
Regolazione guadagno
adjustment
ingresso B.III+DAB
6. PROGRAMMING SOFTWARE
Impostazione dei cluster sulla banda UHF
Setting the clusters on the UHF band
37
Association of the clusters
Associazione dei cluster
to the UHF inputs
agli ingressi UHF