Advanced Programming - Fracarro FIL 10 Instrucciones De Funcionamiento

Note: The self-alignment algorithm does not consider the input signal given in the B.III input, therefore:
• the self-alignment must be performed whit the B.III input disconnected because a signal given in the
input may affect the measurement and setting of the output level.
• B.III level must be adjusted as described at paragraph 5.3.2, considering the possible problems due to
a high input level (i.e. intermodulation);

Advanced programming

To perform an optimal alignment, after performing the self-alignment, proceed as follows:
1. Check the output signal quality by analizing the presence of holes or slope in the spectrum, caused by
the sum in counterphase of the cluster signals.
2. If the previous check is unsuccessful, change the clusters' position or the clusters' dimension (number
of channels associated to the cluster) and execute the self-alignment.
3. Adjust the input dynamics value, finding the best compromise between the output level and the quality
of each channel.
SETTINGS
REMOTE POWER
* UHF3 is not available on model FIL 06
The remote power supply can be enabled individually for the three inputs UHF1, UHF2 and UHF3. From the
"REMOTE POWER - 12V/24V" menu, select the voltage you want (12V or 24V DC); this setting is valid for
all the UHF inputs therefore it is not possible to set the remote power supply at 12V in one input and at 24V
in another input.
The maximum supplied power at 12V is 200mA, at 24V maximum 100mA.
The activation of the UHFx input remote power supply will be signaled by the switching the red LED on next
to the UHFx input.
5.5 REMOTE POWER MENU
REMOTE POWER
TELE. 12V/24V
REMOTE POWER
TELE. UHF1
REMOTE POWER
TELE. UHF2
REMOTE POWER
*
TELE. UHF3
TELE.12V/24V
Warning 12V
12V
YES=V / NO=X
Warning 24V
TELE.12V/24V
YES=V / NO=X
24V
UHF1 12V
24V
OFF
To select
UHF1 12V
24V
ON
UHF2 12V
24V
OFF
To select
UHF2 12V
24V
ON
UHF3 12V
24V
OFF
To select
UHF3 12V
24V
ON
36
Setting the remote power
supply voltage at 12V or 24V
To select
Enabling the remote power
supply of the UHF1 input
Enabling the remote power
supply of the UHF2 input
Enabling the remote power
supply of the UHF3 input