Fracarro FIL 10 Instrucciones De Funcionamiento página 31

CONTROL
UNIT SETUP
Setting the access
PIN (default 1234)
Setting the LCD
contrast.
Accepted values 0...
15
Load/Save
configuration from/to
USB
Setting the
serial port speed
Reading the installed
software version
Default Reset:
restore the unit to the
factory settings
In the CONTROL UNIT menu, it is possible to change the menu language, set the PIN code, modify the LCD
contrast, save the headend configuration in a USB pen drive, load a configuration from a USB pen drive,
change the communication speed of the serial port (we recommend 57600 bps), check the software version
of the unit, and reset the unit to the default settings.
5.2 CONTROL UNIT MENU
Select language from the
programming menu
CONTROL UNIT
LANGUAGE
LANGUAGE
LANGUAGE
USER CODE
CONTROL UNIT
USER CODE YES
USER CODE
NO
LCD CONTRAST
CONTROL UNIT
LCD CONTRAST
LCD CONTRAST
USB
CONTROL UNIT
STORAGE
USB STORAGE
LOAD
USB STORAGE
SAVE AS
CONTROL UNIT SERIAL SPEED
SERIAL SPEED 115200 bps
SERIAL SPEED
9600 bps
CONTROL UNIT .
SOFTWARE VERSION
SOFTWARE
VERSION
CONTROL UNIT Default Reset?
YES=V / NO=X
DEFAULT RESET
Italiano
To select
English
Enter code
****
Code disabiled
0
To select
15
Enter USB
Press DOWN to
YES=V / NO=X
scroll down the
Enter USB
Configuration1
YES=V / NO=X
To select
version
31
Italiano
Francais
Espanol
Portuguese
Deutsch
English
Re-enter code
****
LOAD
LOAD
Configuration1
files
SAVE AS
SAVE AS
Saving OK
9600 bps
19200 bps
38400 bps
57600 bps (default value)
115200 bps