Installation; Right Place For Installation; Attaching The Plastic Wedges; Adjusting The Stands - Beko RCNE560E40ZXP Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 199
3

Installation

3.1. Right place for installation

Contact the Authorized Service for the product's
installation. To ready the product for installation, see
the information in the user guide and make sure the
electric and water utilities are as required. If not, call
an electrician and plumber to arrange the utilities as
necessary.
WARNING:
no responsibility for any damage caused
B
by the work carried out by unauthorized
persons.
WARNING:
must be unplugged during installation.
B
Failure to do so may result in death or
serious injuries!
WARNING:
for the product to pass, remove the door
A
and turn the product sideways; if this does
not work, contact the authorized service.
• Place the product on a flat surface to avoid vibration.
• Place the product at least 30 cm away from the
heater, stove and similar sources of heat and at least
5 cm away from electric ovens.
• Do not expose the product to direct sunlight or keep
in damp environments.
• The product requires adequate air circulation to
function efficiently.
• If the product will be placed in an alcove, remember
to leave at least 5 cm distance between the product
and the ceiling and the walls.
• Do not install the product in environments with
temperatures below -5°C.

3.2. Attaching the plastic wedges

Use the plastic wedges in the provided with the product
to provide sufficient space for air circulation between the
product and the wall.
1.
To attach the wedges, remove the screws on the product
and use the screws provided with the wedges.
2.
Attach 2 plastic wedges on the ventilation cover as shown
in the figure.
The manufacturer assumes
The product's power cable
If the door span is too narrow

3.3. Adjusting the stands

If the product is not in balanced position, adjust the front
adjustable stands by rotating right or left.

3.4. Power connection

WARNING:
A
sockets in power connection.
WARNING:
B
be replaced by Authorized Service.
When placing two coolers in adjacent
C
position, leave at least 4 cm distance
between the two units.
Our firm will not assume responsibility for any
damages due to usage without earthing and
power connection in compliance with national
regulations.
The power cable plug must be easily accessible
after installation.
Do not use multi-group plug with or without
extension cable between the wall socket and the
refrigerator.
Hot Surface Warning!
Side walls of your product is equipped
with refrigerant pipes to improve the
cooling system. Refrigerant with high
temperatures may flow through these
C
areas, resulting in hot surfaces on the
side walls. This is normal and does not
need any servicing. Please pay attention
while touching these areas.
8 /35 EN
Do not use extension or multi
Damaged power cable must
Refrigerator / User Guide

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido