Potential Cause - Oster 6081 Manual De Instrucciones

CLEANING YOUR OVEN
Step 1. Turn all knobs to off position then unplug unit and let it cool.
Step 2. Wipe unit down with damp cloth. DO NOT IMMERSE IN WATER. Make sure to
only use mild, soapy water. Abrasive cleaners, scrubbing brushes and chemical
cleaners will damage the coating on this unit.
Step 3. Remove crumb tray by pulling out of the oven.
Step 4. Shake off crumbs from crumb tray. Cleaning the crumb tray often will avoid any
accumulations.
Step 5. Remove wire rack and clean with damp cloth or place in top rack of dishwasher.
STORING YOUR OVEN
Allow the appliance to cool completely before storing. If storing the oven for long periods
of time make certain that the oven is clean and free of food particles. Store the oven in a
dry location such as on a table or countertop or cupboard shelf. Wind the electrical cord
around the cord storage brackets. Other than the recommended cleaning, no further user
maintenance should be necessary.
Problem
• Overcooked/
Undercooked
Foods.
• Burnt smell, initial
burn off.
• Oven does not
turn ON.
• Only one heating
element is heating up.
• Heating elements
do not stay ON.
Helpful Tips / Troubleshooting

Potential cause

• Incorrect temperature or
time setting.
• Rack placement.
• Food build-up inside
oven, on heating
elements or in crumb tray.
• Unit is unplugged.
• Turn Timer.
• Function setting selection
determines which heating
element will operate.
• Heating elements will
cycle ON and OFF to
maintain proper heat.
• You may have to adjust the time and
temperature to desired taste.
• Because your oven is smaller than
your regular oven, it will heat up
faster and generally cook in shorter
periods of time.
• Refer to "Positioning Rack"
Section. Rack may need
to be adjusted to accommodate
food type.
• Refer to "Cleaning Your
oven" Section.
• Refer to "Cleaning Your Countertop
Oven" Section.
• Set timer knob and temperature
knob to desired setting. Both
must be turned on to
operate the oven.
• Check to see if the broil "Asar"
setting is selected.
• Confirm function setting is the
correct one of choice.
8
Solution