Motor Set-Up - ABB ACS850 Guia De Inicio Rapido

Quick Start-up Guide for ACS850 with Standard Control Program 7
Application macros are pre-defined parameter
settings that can be used as a basis for user
applications. The following macros are available:
• Factory (for speed control applications where a
simple start/stop interface is required)
• Hand/Auto (for speed control applications where
two external control devices are used)
• PID control (for process control applications
such as closed-loop pressure, level or flow control
systems)
• Torque control (for torque and/or speed control
of motor)
• Sequential control (for speed control
applications in which multiple constant speeds
and acceleration/deceleration ramps are needed
and are sequenced).
More information on the macros is available in the
Firmware Manual.
Highlight one of the macros and press OK.
After the text "Done OK" appears on the control panel, press OK to complete the
firmware assistant.
Ensure you have the motor nameplate and encoder data (if needed) at hand.
In the Main menu, highlight ASSISTANTS and press
ENTER.
Highlight Motor Set-up and press OK.
The assistant will guide you through the motor set-
up.
Select the motor type, AM (asynchronous squirrel
cage AC motor) or PMSM (permanent magnet
synchronous motor).
2 – Motor set-up
Parameter defaults for the macro
are applied.
LOC MAIN MENU
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT
LOC CHOICE
Select assistant
Application Macro

Motor Set-up

Start/Stop Control
EXIT
99.04 Motor type
1
ENTER
OK