Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
See page 4.
A Chargers
B Battery packs with different capacities
Use only battery packs with voltage suitable for
your power tool.
C Screwdriving bits
For a complete range of accessories, see
www.metabo.com or the catalogue.
8. Repairs
Repairs to electrical tools must ONLY be
carried out by qualified electricians!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. See
www.metabo.com for addresses.
You can download a list of spare parts from
www.metabo.com.
9. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
10. Technical Specifications
Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
U
= voltage
(max. voltage = 12 V,
nominal voltage = 10.8 V)
n
= No-load speed
0
S
= impact frequency
H
= machine tool holder
m
= weight (with the smallest battery pack)
M
= max. tightening torque
max
Permitted ambient temperature during operation: -
20 °C bis 50 °C (limited performance with
temperatures below 0 °C). Permitted ambient
temperature for storage: 0 °C to 30 °C
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 62841:
a
= Vibration emission value (screwdriving with
h
impact)
K
= Uncertainty (vibration)
h
Typical A-weighted sound levels:
L
= Sound-pressure level
pa
L
= Acoustic power level
WA
K
, K
= Uncertainty (noise level)
pA
WA
Wear ear protectors!
ENGLISH en
9
Publicidad
Tabla de contenido
