Playback Mode; Playing Back A Tape - Panasonic DIGITAL Palmcorder PV-GS69 Instrucciones De Operación

Playback Mode

Playing Back a Tape

The recorded scene can be played back immediately
after the recording.
• Open the LCD Monitor or extend the Viewfinder
before turning on the power.
1
Set the [OFF/ON] Switch to [ON].
• The [STATUS] Indicator lights Red.
2
Set the Mode Dial to Tape Playback Mode.
• The [ TAPE PLAYBACK MODE] is displayed
on the screen.
• The One-Touch Navigation icon is displayed
on the lower right of the screen.
(PV-GS39/
(PV-GS29)
PV-GS69)
3
Move the Joystick Control [◄] to rewind
the tape.
• Rewind the tape to the point where you want to
start playback.
• When the tape reaches the beginning,
rewinding stops automatically.
4
Move the Joystick Control [▲] to start
playback.
• The [►] Indication appears.
S P 3 h 5 9 m 5 9 s 2 9 f
1 2 : 3 4 : 5 6 A M
J A N 2 2 0 0 6
• If a cassette recorded with copyright protection
signal is played back, the picture is distorted by
mosaic-like patterns.
To Pause Playback
Move the Joystick Control [▲] to select [
during playback.
To Stop Playback
Move the Joystick Control [▼] to select [
[One-Touch Navigation icon]
R 2 : 0 0
2 8
]
].
Adjusting the Sound Volume
Adjust the speaker volume for playback.
1
Push the [– / VOL +] Lever to adjust the
volume.
• Towards [+]: increases the volume
Towards [–]: decreases the volume
(Nearer the bar to [+], larger the volume.)
On the Remote Control, press the [T] Button to
increase the volume or the [W] Button to decrease it.
(PV-GS69 Only)
S P 3 h 5 9 m 5 9 s 2 9 f
1 2 : 3 4 : 5 6 A M
J A N 2 2 0 0 6
Notes:
• When the adjustment is completed, the volume
indication [ ] will disappear.
• If you do not hear the sound, check the settings of
[ SETUP] >> [ 12bit AUDIO].
Repeat Playback
When the tape end is reached, the tape will be
rewound and played back again.
1
Set [ ADVANCED] >> [
>> [ON].
2
Move the Joystick Control [▲] to start
playback.
• The [ ►] Indication appears.
To cancel Repeat Playback Mode
Set [ REPEAT PLAY] >> [OFF] or set [OFF/ON]
Switch to [OFF].
• When you set [ USB FUNCTION] >> [WEB
CAM] and then connect the USB Cable, the
Repeat Playback Mode is canceled.
Settings on the audio
• If you cannot listen to the desired audio when
playing back a tape, check the settings in
[ SETUP] >> [ 12bit AUDIO].
• When you record or dub the audio in [12bit] and
set [ SETUP] >> [ 12bit AUDIO] >> [MIX],
the audio will be played back in stereo sound
regardless of the settings in [
R 2 : 0 0
2 8
REPEAT PLAY]
AUDIO OUT].
47