Recording Yourself; Recording With The Built-In Led Video Light; Quick Start - Panasonic DIGITAL Palmcorder PV-GS69 Instrucciones De Operación

Recording Yourself

You can record yourself while viewing the LCD
Monitor. You can record persons in front of the
camera while presenting them the image. The image
is horizontally flipped as if you see a mirror image.
(The image to be recorded is the same as that
recording.)
• Extend the Viewfinder to see the picture while
recording.
• Set to Tape/Card Recording Mode.
1
Rotate the LCD Monitor towards the lens
side.
• A vertically oriented display appears on the
Viewfinder screen, this is normal and not indicative
of any trouble.
• When the LCD Monitor is rotated towards the
lens side, the One-Touch Navigation icon will not
be displayed even if you press the center of the
Joystick Control.
Recording with the Built-in LED
Video Light
To brighten the natural colors in a scene. Gain Up
mode works with the Built-in Video Light to enhance
the light's brightness.
• Set to Tape/Card Recording Mode.
1
Press the [LIGHT] Button.
• The Built-in LED Video Light lights and the
Gain Up mode is set to on.
• Gain Up mode will be brighter than when only
the Video Light is on, however, washed out
images will appear.
2
Press the [LIGHT] Button.
• Gain Up mode is set to off.
• To eliminate washed out images, use this
mode.
3
Press the [LIGHT] Button.
• The Video Light turns off.
• Pressing the [LIGHT] Button again returns
1
Notes:
• The subject should be within 4.9 feet (1.5 meters)
of the Camcorder.
• Using the LED Video Light reduces battery time.
• Set the LED Video Light to off when not in use.
• Do not look directly into the light.
• If the LED Video light is used with a Conversion
lens attached, a slight vignetting (darkening around
edges) effect occurs on the screen.
• Using the MagicPix Function at the same time will
make conditions even brighter.
• The LED video light enables simply lightening
the images taken in a dimly-lit place. We also
recommend using it in a bright place to obtain high
quality images.

Quick Start

When Quick Start is ON the battery power is still
being consumed, even when the LCD Monitor and
the Viewfinder are closed.
The Camcorder will resume recording/pause mode
about 1.7 seconds after the LCD Monitor and the
Viewfinder are reopened.
• Please note in Quick Start Mode approximately
half the pause recording power is being consumed.
Using Quick Start Mode will reduce the battery
recording/playback time.
• This function is only activated in the following
1
cases:
- A tape or a card is inserted while the Tape
Recording Mode is set.
- A card is inserted while the Card Recording Mode
is set.
• Set to Tape/Card Recording Mode.
1
Set [
[ON].
2
to .
1
2
1 0 0 1 0 0
SETUP] >> [ QUICK START] >>
3
3
1 0 0
35