Plastic Bag - Bosch VAC090S Instrucciones De Funcionamiento Y Seguridad

Ocultar thumbs Ver también para VAC090S:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2610027608_VAC090 VAC140 3/2/17 8:08 AM Page 10
general, fleece bags are the best bags for
dry-vacuuming because they are durable,
they trap dust before it gets to the filter and
allow the least amount of dust to escape at
the time of bag disposal.
• Using a paper, fleece or wet/dry slurry dust
bag extends the amount of time the unit
operates at high performance and extends
the amount of time it takes for the filter to
become clogged.
• The plastic bags and fleece bags can handle
a heavier load without tearing than the paper
or wet/dry slurry bags.
• Using any of the four types of Bosch dust
bags also makes waste disposal much
easier, eliminating the cloud of dust that is
created when canister contents are simply
poured out, helping to protect you and the
environment from exposure to the unwanted
particles and debris.
Wet Vacuuming Notes:
• The wet/dry slurry bags can be used when
vacuuming wet materials. They are ideally
suited for slurry-suction applications.
• The fleece bags and paper bags should not
be used when wet vacuuming because the
water will cause the bag to come apart.
• The plastic bags should not be used when
wet vacuuming because the bag may tear
when removed if it is fully loaded with liquid.
• See WET VACUUMING section for more
information.
filter cleaning must be turned off when
using paper bags. The reversal of air during
filter cleaning may damage the paper bag.
INSTALLING A DUST BAG
1. Unlock the canister latches and remove the
control unit.
2. Make sure to install a bag that is suitable for
the application and has the proper size for
canister.
3. Grasp a new dust bag at the flange. Push it
over the internal dust port first and then over
the raised ring. Make sure the entire flange
is seated in the recessed area of the internal
dust port. Make sure that the dust bag is not
folded over on itself and the full length of the
bag faces the front and bottom of the
canister.
4. For plastic bags only – After the plastic bag
Semi automatic filter
cleaning and automatic
has been attached to the internal dust port,
wrap the upper edges of the plastic bag over
the entire perimeter of the rim at the top of
the canister. Make sure that the plastic bag
does not interfere with the canister latches.
5. Re-attach the control unit.
6. Lock the canister latches.
REMOVING THE DUST BAG
- Unlock the canister latches and remove the
control unit.
If a plastic bag is used:
1. Align the top of the plastic bag. Peel the
cover off the adhesive strip and fold over
onto the plastic bag to seal the top closed.
Save the cover for use in step 4.
2. Remove the plastic bag from the internal
dust port by pulling the bag towards the rear
of the canister.
3. Remove the bag from the canister and twist
the top of the bag.
4. Tie off the plastic bag below the port
opening using the cover that was just
removed from the bag's adhesive strip in
step 1 and dispose of properly.
If a paper, fleece, or wet/dry slurry bag is
used:
1. Remove the bag from the internal dust port
by pulling the flange towards the rear of the
canister.
2. Pull the tab on the flange up until the
opening has been closed off by the paper
cover.
3. Remove the bag from the canister and
dispose of properly.
FIG. 8
HOSE PORT
-10-

PLASTIC BAG

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Vac090aVac140sVac140a

Tabla de contenido