Radio mode
Selecting the waveband/memory
bank
This device can be used to receive stations
in the FM and AM frequency bands. There
are three memory banks available for the
FM waveband (FM1, FM2 and FMT) and
one for the AM waveband.
Five stations can be stored in each memory
bank.
To switch between the memory banks FM1,
FM2 and FMT or the AM waveband,
u
briefl y press the BND/TS ? button.
Tuning into a station
There are various ways of tuning into a sta-
tion.
Automatic station seek tuning
u
Press the
or
The radio tunes into the next receivable sta-
tion.
Tuning into stations manually
You can also tune into stations manually.
u
or button 6.
Press the
Setting the sensitivity of station
seek tuning
You can choose whether the radio should
only tune into stations providing good re-
ception or whether it can also tune into
those with a weak reception.
Press the MENU button :.
u
u
Press the
or
until "SENS" appears on the display
with the current setting.
12
button 6.
button 6 repeatedly
"SENS HI" means that the tuner is set to the
highest sensitivity setting. "SENS LO" means
it is set to the lowest sensitivity setting.
u
Set the desired sensitivity level using
buttons 6.
the
When you have fi nished making your chang-
es,
press the MENU button :.
u
Note:
You can adjust different sensitivities for
FM and AM.
Storing stations
Storing stations manually
u
Select the desired memory bank FM1,
FM2, FMT or the AM waveband.
u
Tune into the desired station.
u
Press and hold down one of the station
buttons 1 - 5 < for longer than two
seconds to assign the station to that
button.
Storing stations automatically
(Travelstore)
You can automatically store the fi ve strong-
est stations in the region. The stations are
stored in the FMT or AM memory bank.
Note:
Any stations that were previously
stored in this memory bank are deleted
in the process.
u
Press and hold down the BND/TS ?
for longer than two seconds.