Replacing No. 820 Cutter Wheel; Jaw Replacement (Auto Chuck Machines); Replacing Jaw Inserts (Manual Chuck Machines) - RIDGID 535M Manual Del Usuario

Top
Plug
Cover
Figure 31 – Priming Model A Pump
To prime the Model A Pump:
1. Remove plug cover located on top cover.
2. Remove plug through opening.
3. Fill pump with oil.
4. Replace plug and plug cover before starting machine
or pump will drain itself immediately.
NOTE! If machine must be primed on a frequent basis, it
is an indication that the pump is in need of repair.

Replacing No. 820 Cutter Wheel

If the cutter wheel becomes dull or broken, push cutter
wheel pin out of frame and check for wear. If needed
replace pin, and install new Cutter Wheel (see RIDGID
catalog). Lubricate pin with light lubricating oil.
Jaw Replacement (Auto Chuck
Machines)
When teeth on jaw become worn and fail to hold pipe or rod
during operation, flip jaws to unused side or replace entire
set of jaws.
1. Loosen all three front cover mounting screws and
remove the front cover. Mounting screws are retained
to front cover.
2. Remove retaining rings and remove front pivot rod
support.
3. Remove jaws from the drive shaft. Flip over to unused
side or replace with new jaws. Make sure keys are
installed.
Confirm that connection links and jaws are in proper
orientation (Figure 32 inset).
999-998-086.10_REV. D
535 Manual Chuck/535 Auto Chuck Threading Machines
Connecting
Link
Key
Figure 32 – Changing Auto Chuck Machine Jaws
4. Reverse process to assemble.
Replacing Jaw Inserts (Manual Chuck
Machines)
If Jaw inserts are worn out and do not grip pipe, they need
to be replaced.
1. Place screwdriver in insert slot and turn 90 degrees in
either direction. Remove insert (Figure 33).
To Remove
Figure 33 – Replacing Jaw Inserts
Jaw
Screw Driver
Insert
Locking
Pin
To Replace
Retaining
Ring
Front
Pivot Rod
Support
PRESS
DOWN
Teeth
19