Activating/Deactivating The Alarm; Temperature Display; Time And Date Setting - Bresser MyTime Duo Instrucciones De Uso

hour at a time. Press the MIN button to set the minutes for the
desired alarm time. Repeatedly press the button to change
one more minute at a time. In order to set the alarm time 2,
press the 12/24 button once. The display for alarm time 2
will flash. The time can be set as per the above instructions.
After setting the alarm time, slide the SET slide-button (8) to
the LOCK position to complete the setting.
Note:
The alarm time setting must be done for both alarm
functions (AL 1 and AL 2) seperately one after another.

ACTIVATING/DEACTIVATING THE ALARM

After finishing the alarm time setting slide the AL ON/OFF
slide-button (3) to the position of the desired alarm function.
The following functions are possible:
Position AL OFF: Alarm deactivated
Position AL 1 ON: Alarm time 1 on
12
Position AL 2 ON: Alarm time 2 on
Position AL 1&2 ON: Alarm times 1 and 2 on
SET 12 OR 24 HOURS SYSTEM
Slide the SET button (8) into LOCK mode. Press to switch
between 12hr or 24hr system. When 'AM' appears, it means
12hr. Press 12/24 YEAR button again, 'AM' will disappear, it
means 24hr system.

TEMPERATURE DISPLAY

Press "MIN" button to switch between °C or °F temperature
display.

TIME AND DATE SETTING

Set year mode:
Slide SET button into DATE SET mode, the date setting mode
will blink. Press 12/24 YEAR button to reach the desired year.