KPS DT30 Manual De Funcionamiento página 11

KPS-DT30 • Voltage tester
tests The phase can be tested at above 220 V. Con-
sting nect the handle (A) with the test electrode (1) to
ssary the installation to be tested. Hold onto the test
tage handle.
Never connect the voltage tester to voltage for
and
more than thirty seconds. If the led (8) -light
e (A)
emitting diodes lighting, then the checker is in
contact with the working phase.
4. Testing DC voltages.
test
The voltage tester can only be used within the
I (3).
nominal voltage scale from 12 to 690 V. Never
(4),
connect the voltage tester to voltage for more
than thirty seconds (Maximum connection period
f the
allowed = 30 s.).
and
Connect the electrodes on the test handles (A)
cates
and (B) to the installation to be tested.
In the case of DC voltage above 12 V, the LED's
(6) and (7) will light up to a greater or lesser ex-
n the
tent. The LED's light up progressively according
to the voltage being tested.
e for
Testing polarity on DC voltage.
ction
The voltage tester can only be used within the
nominal voltage scale from 12 to 690 V.
ndles
Never connect the voltage tester to voltage for
more than thirty seconds (Maximum connection
ED's
period allowed = 30 s.).
r ex-
Connect the electrodes (1) on test handles (A)
rding
and (B) to the installation to be tested.
If LED (6) lights up, "the positive pole" of the
equipment being tested is on test handle (A).
n the
If LED (7) lights up, "the negative pole" of the
equipment being tested is on test handle (A).
11