Bresser MikrOkular-II Instrucciones De Uso página 14

Here, you can select the desired
language. Confirm with „OK".
4. Click „Continue" in the
„Welcome" screen.
5. The next two windows will
ask you for the „Destination
Directory" and the „Program
Folder." Confirm this with
„Continue".
6. The „Setup Status" window
appears. The program files are
copied to your PC. This process
can take a few minutes.
7. The „InstallShield Wizard
Complete" window appears.
Click on „Finish". The image
editing software is now installed.
14
1.3 Troubleshooting: the
device isn't recognised by the
computer (USB)
1. This occurs in rare cases
with some OEM Windows Vista
or XP versions. The device is
not defective. Updating the
notebook or PC USB driver
usually suffices.
2. If not, proceed as below.
(The maker cannot accept any
liability whatsoever in these
1
cases ).
Delete ghost devices. These
are devices not actually
currently connected to your
computer. The reason for this
is that Windows generates a
system settings entry for each
USB device ( e.g USB Stick)
on each port. It then seeks
that/those device/s each time
it's started. This slows down
USB device recognition and
Windows booting and causes
non-recognition of USB ports.
Cleaning up the system envi-
ronment and deleting devices
that are no longer in use helps
here. To do so right click
WORKPLACE (COMPUTER
in Vista) and open the
PROPERTIES menu. Then click
the ADVANCED (ADVANCED
SYSTEM SETTINGS in Vista)
and then ENVIRONMENT
VARIABLES. Choose the NEW
option in ENVIRONMENT
VARIABLES. Enter the following
under VARIABLE NAME.
devmgr_show_nonpre-
sent_devices Under VARIABLE