Assembly Procedure - Pioneer PDK-5006 Manual De Instrucciones

Precautions before assembling
There are 2 sets of vertical frames: one for the right side and one for the left.
When installing, make sure that the hexagonal holes on both are facing outward.
Position the horizontal frame so that the holes with the small diameter are facing the wall.
In all, there are 14 holes for wall installation.
This metal fixture cannot be used when the VIDEO BOX (PDA-5001) is used.

Assembly procedure

Loosen the a screw and remove the hook on one side.
1.
2.
Holding the top sides of the vertical frames, pull each of them apart about 10cm.
3.
Attach the vertical frames to the horizontal frames.
1
3
3
8
<AZR1040>
En
Loosen the screw so that its tip can not be
seen through this hole.
2
The hexagonal holes
are facing outward.
a
1
Wall side surface
2
Wall side surface
(The holes with the small diam-
eter are facing the wall.)
a
3
3
While supporting the screw with your
finger, tighten it using the wrench.
Hexagonal
wrench