Checking The Standard Accessories; Assembling The Stand; Assembly Procedure - Pioneer PDK-TS27 Manual De Instrucciones

Checking the Standard Accessories

Check to make sure that you have all the standard accessories before assembly and installation.
Base cover × 1
Stand pipe (L) × 1
Stand pipe (R) × 1

Assembling the Stand

Assembly Procedure

1
Turn the base cover over so the underside
is facing up.
2
Insert the stand pipes into the base cover.
Insert stand pipe (R) into the side marked "R" and stand
pipe (L) into the side marked "L".
Ensure that the open sides of the stand pipes face
inward. Insert the stand pipes, making sure to match
them to the raised portion of the base cover.
3
Tighten the screws
silver) to stabilize the stand pipes.
Note
Assemble the stand with a soft sheet placed under the base
cover. If a sheet is not laid before assembly, the front surface
of the base cover may be scratched.
Please take care when installing stand pipes (L) and (R) to
ensure that they are in the correct positions. Mistakenly
installing the stand pipes may damage the stand.
Light-blocking shield × 1
(PDK-TS27A and PDK-TS29A only)
1
Screws
(4 mm × 10 mm: silver) × 4
2
Installation screws
(M8 × 60 mm: black) × 2
[for 42 inch display model]
(4 mm × 10 mm:
1
3
Installation screws
(M8 × 40 mm: black) × 2
[for 50 inch display model]
4
Installation screws
(M8 × 23 mm: black) × 2
5
Screws
(M4 × 10 mm: black) × 2
Ensure that the open
1
Screws
sides of the stand pipes
(4 mm x 10 mm: silver)
face inward. Insert the
stand pipes, making
sure to match them to
the raised portion of
the base cover.
Stand
pipe (R)
Base cover
Front
Completed
Table Top Stand
Fall-prevention straps × 2
Operating instructions
(this document) × 1
1
Screws
(4 mm x 10 mm: silver)
Rear
Stand pipe (L)
Sheet
9
En