Checking the Enclosed Parts
Check to make sure that you have all the enclosed parts before assembly and installation.
Table top stand x 1
Support columns S x 2
[short columns]
Support columns L x 2
[long columns]
Spacers x 2
Support Columns/Spacers Used/Not Used Table
The parts of this stand that are used vary depending on the speakers that you have purchased and on their installation
location on the plasma display. Please select the parts you use according to the following table.
Combined speaker
numbers
Not used
PDP-S21-LR
PDP-S22-LR
PDP-S25-LR
PDP-S26-LR
*: Can be used when the screen is located in a high position.
The PDP-S25-LR and the PDP-S26-LR speakers cannot be installed at the bottom of the plasma display.
Note
Speaker installation location
–
Both sides of the plasma display
(or not used)
Bottom of the plasma display
Both sides of the plasma display
(or not used)
Cable binders x 2
Installation screws 1 (M8 x 16 mm: silver) x 4
[used to anchor the support columns and the table top stand]
Installation screws 2
(M8 x 30 mm: black) x 2
Hexagonal wrench x 1
(Diagonal size: 6 mm)
C wrench x 1 (10 mm)
Support columns S
Support columns L
(short columns)
(long columns)
Recommended
Can be used*
Recommended
Can be used*
Cannot be used
Used
Can be used*
Recommended
Installation screws 3
(M8 x 40 mm: black) x 2
Operating instructions
(this document) x 1
Table top stand
Support de couverture de table
Tischständer
Supporto di tavolo
Tafelbladstaander
Soporte de mesa
PDK-TS05
Operating instructions
Mode d'emploi
Bedienungsanleitung
Istruzioni per l'uso
Gebruiksaanwijzing
Manual de instrucciones
Spacers
Cannot be used
Cannot be used
Used
Cannot be used
15
En