Checking The Standard Accessories; Assembling The Stand; Assembly Procedure - Pioneer PDK-TS10 Manual De Instrucciones

Checking the Standard Accessories

Check to make sure that you have all the standard accessories before assembly and installation.
Base cover x 1
1
Screws (4 x 10 mm) x 4
2
Installation bolts
(M8 x 20 mm: black) x 2

Assembling the Stand

Assembly Procedure

1
Turn the base cover over so the
underside is facing up.
2
Insert the stand pipes into the base
cover.
3
Tighten the screws to stabilize the
stand pipes.
Stand pipes
(left and right, interchangeable) x 2
3
Installation bolts
(M8 x 40 mm: black) x 2
1
Screws
(4 x 10 mm)
Base cover
Hexagonal wrench x 1
(Opposite side 6 mm for M8 use)
Operating instructions
(this document) x 1
Table top stand
Support de couverture de table
Soporte de mesa
PDK-TS10
Operating instructions
Mode d'emploi
Manual de instrucciones
Stand pipe
Stand pipe
1
Screws
(4 x 10 mm)
3
En