Set-Up, Operation; Setting Up The Machine; Other Risks; Prior To Initial Operation - Festool PRECISIO CS 70 EBG Manual De Instrucciones Original

Sound pressure level
Sound power level
Measuring uncertainty allowance
CAUTION
The noise produced during work may damage
your hearing.
fWear ear protection!
- The specified noise emission levels have been
measured in accordance with the standard test-
ing method and can be used to compare tools.
- The specified noise emissions can also be used
for making preliminary estimates regarding
noise load.
CAUTION
The noise emissions during actual use of the
power tool can differ from the declared va-
lues depending on the ways in which the tool
is used especially what kind of workpiece is
processed.
fIdentify safety measures to protect the opera-
tor that are based on an estimation of expos-
ure in the actual conditions of use (taking ac-
count of all parts of the operating cycle such
as the times when the tool is switched off and
when it is running idle in addition to the trig-
ger time).
5.5

Other risks

In spite of compliance with all relevant design
regulations, dangers may still present them-
selves when the machine is operated, e.g.:
- Workpiece parts being thrown off,
- Parts of damaged tools being thrown off,
- Noise emissions,
- Wood dust emissions.
L = 84 dB(A) 6
PA
L = 98 dB(A)
WA
K = 3 dB
Risk of accident if the machine is operated us-
ing the incorrect voltage or frequency.
fThe line voltage and frequency of the power
fOnly Festool machines with a rated voltage of
fBefore use always inspect the flexible lead
fOutside the premise use only approved ex-
6.1
Ensure that the floor around the machine is lev-
el, in good condition and free of loose objects
(e.g. chips and offcuts).
L
fTo unfold the legs: Loosen the four rotary
fUnfold the legs [1-1] and tighten the rotary
If the machine wobbles, the length of one leg can
be adjusted by turning the end cap [1-12] until
the machine stands securely.
6.2
6.2a
fScrew the supplied rotary knob [2-6] anti-
6.2b
fSet the saw to maximum cutting depth and the
fPull the wedge [12-8] into the upper position.
fTake hold of the guard and completely unscrew
fPlace the guard on the riving knife [12-8].

Set-up, operation

WARNING
supply must match those specified on the
machine's rating plate.
120 Volt may be used in North America.
and the plug. Have the defects repaired by a
specialist repair shop.
tension leads and cable connections.

Setting up the machine

The machine can be set up with or without
the legs unfolded.
knobs [1-11] all the way.
knobs [1-11] again.

Prior to initial operation

Fitting the knob
clockwise into the guide rod.
Fitting the guard [1-8]
mitre to 0°.
the screw [12-5].
Guide the lengthwise pin that is located in the
guard into the groove [12-9] on the wedge
[12-8] [12-6] and push the screw [12-5] back
into the guard and though the hole [12-7] in
the riving knife, then tighten it.
-
P R E C I S I O GB
27