Technical Specifications; Noise Conditions - Fox F36-527C Manual De Instrucciones

EN

TECHNICAL SPECIFICATIONS

Engine power: .................................................................................................................................................. 1500 W
Voltage and frequency: .......................................................................................................................... 230 V - 50 Hz
Service: ....................................................................................................................................................... continuous
Blade diameter: ............................................................................................................................................... 254 mm
Blade body width when assembled: ................................................................................................................ 1,8 mm
Cutting width when the blade is assembled: ................................................................................................... 2,8 mm
Bore diameter: .................................................................................................................................................. 30 mm
Rotational speed: ........................................................................................................................................ 4500 RPM
Riving knife and holes width: .............................................................................................................. 2 mm – 6,2 mm
Cutting height at 90°: ........................................................................................................................................ 80 mm
Cutting height at 45°: ........................................................................................................................................ 55 mm
Workbench dimensions: ....................................................................................................................... 638 x 430 mm
Workbench extensions: ........................................................................................................................ 638 x 260 mm
Blade angle: ........................................................................................................................................... from 0 to 45 °
Pointing device class: ............................................................................................................................................... 1°
Laser power: ................................................................................................................................................ < 111 mW
Net weight: .......................................................................................................................................................... 38 Kg

NOISE CONDITIONS

The noise emitted, measured in conformity with the standards EN 3744 and EN 11201 is:
- Sound pressure level LpA ......................................................................................................................... 99,3 dB(A)
L
- Sound power level WA ......................................................................................................................... 112,3 dB(A)
- Uncertainty of measurement K .......................................................................................................................... 3 dB.
We recommend you to use ear protection devices.
The sources of the noise of the saw are the electric engine and its ventilation system, the blade and the material to
be cut.
We advise you to control the engine, its ventilation system and the aspiration passages. Check the condition and
tension of the belt. As far as the saw blade is concerned, it is preferable to use silenced type of blades and to keep
them in good conditions. We recommend you to use the correct saw blade and to keep firmly the workpiece to be
cut.
Noise levels are emission levels and do not necessarily indicate safe working conditions. Even if there is a
connection between emission levels and exposure levels, the first ones cannot be used to determine safely if other
precautions are necessary. The factors that can influence the actual exposure level of the operator include
exposure length, environment features and other sources of noise, as for example the number of machines and
operations present. Besides, exposure levels can change from country to country. However, these instructions
enable the user of the machine to better evaluate the dangers and risks.
44