Assembly Of Workbench's Back Extension; Assembly Of The Pusher Hanger - Fox F36-527C Manual De Instrucciones

ASSEMBLY OF WORKBENCH'S BACK EXTENSION

1. Use 3 M5 x 16 mm screws, each with a washer and
a stop washer (Z) to fix the extension (F) to the
saw's workbench.
2. Use 2 M5 x 20 mm screws with the washers to fix
the supporting parts (L) to the saw's base.
3. Use the two M5 x 20 mm screws with the washers
and the nuts to fix the supporting parts to the back
extension (F).
To assemble the pusher hanger observe the following pictures.
1

ASSEMBLY OF THE PUSHER HANGER

2
52
EN
3