Assembly Of The Miller - Fox F36-527C Manual De Instrucciones

To assemble the miller, you have to use the fixing plate of the miller (see
picture on the side). Fix the base of your miller on this plate, after
checking the dimensions of the miller under the workbench. Given the
peculiarity of the miller support, every miller needs a different drilling of the
fixing plate.
After fixing your tool on the plate, fix the whole group under the workbench
with the screws.
After stopping using the miller function, disassemble the accessories and
re-assemble the tool according to the table saw function as illustrated
previously.
You are responsible for using other materials and electrical tools
with this table saw. You have to take every precaution to avoid
possible risks during working and, then, always remove the tool and
all accessories before switching to the table saw function.
We cannot be held responsible for any failure, damage, or injury
which occur to the tool or to people when using electrical portable
tools (not supplied) assembled on this table saw (es. miller, jig saws,
etc.).
For safety reasons, this option is provided with a safety switch on which
you have to connect your saw and the possible electrical portable miller.
This safety switch prevents the simultaneous start of the two functions. It
is a lever switch that allows you to feed the circular saw or the miller, but
never the two functions at the same time.
The miller's guide is composed by the assembly of plastic parts that allows you to guide the wood piece against
the tool.
Figure 1
1. First fix the two plastic pieces indicated in fig. 1 and 2 through two 30 mm round head square neck bolts
and 2 knurled knobs. In fig. 1, number 1 indicates the holes you must use only in final phase. These two
pieces are used as vertical clamp for the workpiece.
EN

ASSEMBLY OF THE MILLER

Figure 2
62
Figure 3