Hitachi CG47EJ Manual Del Propietário página 4

Max
9,900rpm
Shows maximum shaft speed. Do not use the
cutting attachment whose max rpm is below
the shaft rpm.
Gloves should be worn when necessary, e. g.,
when assembling cutting equipment.
Use anti-slip and sturdy footwear.
Before using your machine
Read the manual carefully.
Check that the cutting equipment is correctly assembled and adjusted.
Start the unit and check the carburetor adjustment. See "Maintenance".
Blade thrust may occur when the spinning
blade contacts a solid object in the critical area.
A dangerous reaction may occur causing the
entire unit and operator to be thrust violently.
This reaction is called BLADE THRUST. As a
result, the operator may lose control of the unit
which may cause serious or fatal injury. Blade
thrust is more likely to occur in areas where it is
difficult to see the material to be cut.
Explains choke position. Upper sign indicates
choke closed and the lower fully open.
D o n o t a t t a c h
h a n d l e a b o v e
t h i s p o i n t
Indicate handle location. Do not attach
handle above this point.
G
B
GB-3