Exchanging / Shifting The Interface Adapters; Seat Depth; Position Of Seat Bars; Mounting Of Seating Systems - Ottobock Discovery Instrucciones De Uso

Delivery / Preparing the Mobility Base for Use

Exchanging / Shifting the Interface Adapters

At the moment, the following types of interface adapters for seating systems are available:
1 Parallel adaption
2 Trapezoid adaption
3 R82/Ato Form
Models 1 - 4 After loosening the screw connections (Fig. 1, item A) on the seat bars, the interface adapter
(Fig. 1, item B) can be shifted or exchanged.
Models 5 + 6 Slide the interface adapters (Fig. 2) onto the seat bars and tighten the screws. For this purpose it
is necessary to remove the attachment device for the backrest from the seat bars.
A
Figure 3

Seat Depth

The seat depth can be set by selecting one of the four seat depth positions (Fig. 3).
To change the depth position, the fixing screws of the attachment device for the backrest (Fig. 3, item A) and the
screws of the gas compression spring attachment (Fig. 3, item B) must be removed on the left and on the right.
Then the attachment device for the backrest can be moved on the seat bar for adjustment.
The back frame doesn't need to be disassembled when setting the seat depth.

Position of Seat Bars

After removing the screw connections to the basic frame (Fig. 4, item A), the seat bars can be shifted by 2.5 cm,
e.g. to provide more space for the footrests or for center of gravity shifting.
After you have finished adjustment, thoroughly re-tighten all screws.

Mounting of Seating Systems

When using seating systems of other manufacturers, please observe the corresponding manufacturer's
instructions for use.
Ottobock will assume no liability for combinations with interface adapters not listed under 'Exchanging / Shifting
the Interface Adapters'.
Figure 5
26 | Ottobock
5 Dräger
6 Shape/Moss (Fig. 2, item A)
7 Universal crossbars (Fig. 2, item B)
B
A
Figure 4
Figure 6
Discovery