Safety Notes - Hella RALLYE 4000i XENON Instrucciones De Montaje

Mounting steps:
Page 6, 7, 8, 15
With regard to the mounting height,
there are no special regulations for
the lights.
15
max.
4 m
It is possible to mount the lights
in an upright or pendant position.
The lights must not vibrate or jut
out above the bonnet, and must be
mounted symmetrically. Determine
the mounting position and mark
the fastening points. Drill using a 3
mm drill bit, and drill out to 11 mm.
Seal drilled metal parts with rust
protection. When fitting the lights,
Ensure that the „TOP" marking
on the housing always points up-
wards. Light points upwards. Align
the light in accordance with the
drawing and tighten the screws.
Lay and connect the cables in ac-
cordance with the circuit diagram.
According to circuit diagram
the auxiliary lights are switched
on together with the existing spot-
lights. According to circuit diagram
II , the auxiliary lights are swit-
ched on in addition to the existing
headlights via a separate switch.
It is however essential that coun-
try-specific laws are observed.
Check the lighting system, fasten
the connection cables securely.
Have the spotlights adjusted at a
specialist garage.
Only correctly adjusted lights
provide optimum light.
Electrical connection:
From page 9, 10
Fit the relay with the connection
terminals pointing downwards in a
waterproof manner. If required and
if legally permitted, fit a switch in
the dashboard.
Bulb replacement:
I ,
From page 11
Replace bulb in accordance with
the drawing. Do not touch bulbs
with bare fingers! Use a paper
towel or similar.

Safety notes:

Always switch off headlights and
disconnect the supply voltage prior
to replacing a bulb.
IMPORTANT!
Never operate the ballast
without bulb as this may cause
dangerous breakdown voltages
at the plug which will cause
damage.