Waeco CoolFreeze CF11 Instrucciones De Uso página 31

CoolFreeze
I
NOTE
When the cooling device is switched off by the battery monitor due
to low voltage, the display (fig. 2 5, page 3) switches off and the
"Power" LED (fig. 2 2, page 3) flashes orange.
In HIGH mode, the battery monitor responds faster than at the levels "LOW"
and "MED" (see the following table).
CF11, CF16, CF26:
Battery monitor mode
Cut-off voltage at 12 V
Cut-in voltage at 12 V
Cut-off voltage at 24 V
Cut-in voltage at 24 V
This is how to select the battery monitor mode (fig. 1, page 3, fig. 2,
page 3):
➤ Switch on the cooler.
➤ Press the "SET" button (4) three times.
➤ Use the "+" (6) and "–" (7) buttons to select the battery monitor mode..
✓ The selected mode then appears in the display for a few seconds. The
display flashes several times before it returns to the current temperature.
I
NOTE
When the cooler is supplied by the starter battery, select the bat-
tery monitor mode HIGH. When the cooler is connected to a sup-
ply battery, the battery monitor mode LOW will suffice.
If you wish to operate the cooling device from the AC mains, set
the battery monitor to LOW.
EN
Operation
LOW MED
10.1 V 11.4 V
11.1 V 12.2 V
21.5 V 24.1 V
23.0 V 25.3 V
HIGH
11.8 V
12.6 V
24.6 V
26.2 V
31