Technical Description - Waeco DC-Kit2 Instrucciones De Montaje

Technical description

6 Technical description
The DC-Kit2 extension kit enables Dometic roof air conditioners to be used
in vehicles with 12 Vg. The extension kit consists of the following compo-
nents:
 The ECL-102 charging current distributor with low voltage protection reg-
ulates the power distribution between the starter battery, supply battery
and lightmachine. This prevents the battery and the electronics in the
vehicle from overloading.
 The PP2002 inverter supplies the roof air conditioner with the required
input voltage of 230 Vw. The inverter generates the 230 V input voltage
from the 12 V on-board electricity supply in the vehicle.
Remote control FB1 can switch the inverter on and off (applies to
CA2500/B2200/B1600 Plus, FJ1100/FJ1700/ FJ2200/FL1600/
FL2200).
The integrated priority circuit can be used for distributing the voltage in
the vehicle with two available power sources. If a mains voltage and volt-
age created by the inverter (vehicle battery) are both connected to the
device, the use of the mains voltage has priority. If the only voltage avail-
able is that generated by the inverter, the power supply from the battery
is used. This ensures that the limited power of the battery is not used
unnecessarily.
 B1600: The FB2 remote control can switch the inverter on and off.
30
DC-Kit2
EN