Switching On The System - Waeco DC-Kit2 Instrucciones De Montaje

Using the DC kit
8.1

Switching on the system

Observe the following instructions before you switch on the system:
 Air the vehicle.
 Make sure that the ventilation slots on the air nozzles and the fan of the
components are not covered up.
 Make sure that all the housings and cables are not damaged and that all
the insulation is intact.
 Compare the existing supply voltage with the technical data.
 Do not insert any fingers or objects into component openings.
I
NOTE
CA2500, B2200, B1600 Plus, FJ1100, FJ1700, FJ2200,
FL1600, FL2200: the remote control for the roof air conditioner
can only be used if the air conditioning is supplied with 230 V
mains network or with the inverter.
Stationary mode: 230 Vw mains operation
The system is supplied with 230 Vw from the mains. Leave the inverter
switched off. The socket on the inverter supplies electricity.
Driving mode: power supply from the 12 V battery
➤ Switch on the inverter using the remote control.
A
NOTICE!
CA2500, B2200, B1600 Plus, FJ1100, FJ1700, FJ2200,
FL1600, FL2200: the inverter may be damaged.
Do not switch on the roof air conditioner in the automatic or heat-
ing modes.
➤ Use the roof air conditioner as described in the operating manual.
38
DC-Kit2
EN