Compact Discs; Basic Operation - Denon DN-D4500 Instrucciones De Operación

ENGLISH
i
Play Position indicators
• Play position indicator:
The 30 white dots indicate where is playing
visually in a track in the normal play.
• End of Message:
When the time remaining to the end of the
track is less than the specified time, the
EOM(End Of Message) play position indicator
flashes along with the remaining time, a
notification to the user that the track will end
soon.
The EOM time can be set within the preset
mode.
o
Pitch display
• This numeric indicator display the playback
speed (pitch).
!0
MP3 indicators
• Lights when an MP3 disc is detected.

COMPACT DISCS

4
(1) Precautions on handling compact discs
• Do not allow fingerprints, oil or dust on the surface of the compact disc. If the signal surface is dirty, wipe it
off with a soft, dry cloth. Wipe in circular motions from the center and out.
• Do not use water, benzene, thinner, record sprays, electrostatic proof chemicals, or silicone-treated cloth to
clean discs. Do not clean the disc using your shirt or pants, as this will cause damage to the disc.
• Always use care when handling discs to prevent damaging the surface, in particular when removing a disc
from the case and returning it.
• Do not bend compact discs.
• Do not apply heat to compact discs.
• Do not enlarge the hole in the center of the disc.
• Do not write on the disc and do not attach any labels.
• Condensation will from on the disc surface if it is brought into a warm room from a cold area, such as outdoors
during winter. Wait until the condensation disappears. Never dry discs with hair dryers, etc.
(2) Precautions on storage
• After playing a disc, always return it to its case.
• Keep discs in the cases when they are not to be played. This will protect them from dust and dirt and prolong
their service life.
• Do not store discs in the following places:
1) Places exposed to direct sunlight for a considerable time.
2) Places subject to accumulation of dust or high humidity.
3) Places exposed to high temperatures, such as close to heater outlets.
10

BASIC OPERATION

5
(1) PLAY/PAUSE and CUE
• The operation switches between playback and
pause each time the PLAY/PAUSE button !1 is
pushed.
• When the CUE button !0 is pushed during playback,
the pickup returns to the position at which playback
was started.
The diagrams below show playback patterns when the
PLAY/PAUSE and CUE buttons are pushed.
PLAY and PAUSE
PLAY/PAUSE PLAY/PAUSE
button pushed button pushed
PLAY/PAUSE
button pushed
Position
on disc
Section Section
played played
Pause mode set at this point
When the PLAY/PAUSE button !1 is pushed, playback
starts and proceeds as shown by the arrow on the
diagram above.
If the PLAY/PAUSE button !1 is pushed again during
playback, the pause mode is set at that point. Push the
PLAY/PAUSE button !1 again to resume playback.
PLAY and CUE
PLAY/PAUSE CUE button
button pushed pushed
Position on disc
Section
played
Back CUE
When the CUE button !0 is pushed after starting
playback by pushing the PLAY/PAUSE button !1 , the
pickup returns to the position at which playback was
started and prepares for the next playback.
Push the PLAY/PAUSE !1 and CUE !0 buttons
alternately to start playback repeatedly from the same
position. (Checking the playback position)
This function is called "Back CUE".
PLAY, PAUSE and CUE
PLAY/PAUSE PLAY/PAUSE PLAY/PAUSE CUE button
button pushed button pushed button pushed pushed
Position
on disc
Section Section
played played
If the pause mode is set and playback is then
resumed, the position to which the pickup returns with
the Back CUE function changes.