Regeneration Cycle (Only Soft Versions); Switching Off The Machine - Fagor evo Serie Instrucciones De Instalación, Uso Y Mantenimiento

Lavavajillas
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN
5.1.10.2 Drainage using the drainage pump
The drainage using the drainage pump option is only available on request in the A, B models. The
drainage pipe must always be fitted on a siphon to prevent the return of odours.To drain the machine
using this method, proceed as follows:
Remove the overflow valve.
Select the drainage function on the selector switch (G).
Press START (B) button, the START button light (B) comes on, the drainage cycle will start
automatically.
At the end of the cycle (approx. 160 s), the START button light (B) goes off, replace the
overflow valve. The machine may be switched off.
In the C models, to drain the machine using the drainage pump close the door and press ON/OFF
button for 1,5 seconds. The drainage cycle will start automatically at 5 minutes.

5.1.11 Regeneration cycle (only SOFT versions)

In the A, B models, the dishwasher is fitted with a manual regeneration or descaling system for water
with hardness equal to or greater than 10 ⁰f. This means that the water entering the machine must
be softened. If this system is not fitted, the machine pipes may become blocked due to the build-up
of too much limescale. To ensure that the system operates correctly, proceed as follows:
Make sure that the deposit contains rock salt. SEE PILOT LIGHT (J).
The regeneration cycle should be run at the end of each working day.
The process takes 20 minutes, during which the machine cannot be used for washing.
To run the regeneration cycle, proceed as follows:
Select regeneration cycle (H).
Press the START (B) button, the START button light (B) comes on.
After 20 minutes, the START button light (B) goes off, the machine may be switched off.
In the C models, the dishwasher is fitted with an automatic regeneration or descaling system for
water with hardness equal to or greater than 10 ⁰f. This means that the water entering the machine
must be softened. If this system is not fitted, the machine pipes may become blocked due to the
build-up of too much limescale. To ensure that this system operates efficiently, the salt deposit must
be filled with rock salt. If the deposit does not contain salt, a warning advising the user is displayed
(A5- SALT LOW).
The regeneration process is automatic and can be run at the same time as a wash programme.
During the regeneration process, the machine does not run the rinse cycle, but waits until the end of
the regeneration cycle (less than 3 minutes).
When the machine has been switched off, the control may consider another regeneration to be
necessary. In this case, the machine will run an automatic regeneration, and the message
"REGENERATION" is displayed.
The appearance of streaks of lime on the clean dishes is an indication of the need to
urgently run the descaling or regeneration cycle.

5.1.12 Switching off the machine

In the A, B models, to switch off the machine, turn the selector to 0.
In the C models, the dishwasher is switched off by pressing the ON-OFF button for 1.5 seconds.
The machine should not be switched off during the wash process as this will stop the tableware
inside the machine from being cleaned properly.
42
To drain the machine with the drainage pump, the hose must be at a
height (max. 800 mm).

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

EvoconceptEvoadvance

Tabla de contenido