SOMFY Dexxo Pro io Serie Manual De Instalación página 18

Pedestrian door safety function
Opening a pedestrian door within the garage door will prevent the door from moving.
The light will flash for 30 seconds during this process.
Flashing orange light
The orange warning light will flash every time the door moves.
A two second delay before the door starts to move can be selected during installation.
Remote lighting operation
The light comes on every time the motor drive unit is operated. The light will go out one minute after the door stops moving. The time delay can be
adjusted during installation.
Partial opening operation
If this option is selected:
• A short press on the remote control button will partially open the door
• A long press on the remote control button will fully open the door
The partially open position will only operate from the closed position.
Automatic closure mode operation
The door is automatically closed after a time delay set at the time of installation.
An additional command during this time will cancel the automatic closure and the door will remain open.
The next command will close the door.
Working from the back-up battery
If a back-up battery is installed, the Dexxo Pro motor will operate when a power cut occurs.
The following conditions apply to operation:
• Door speed is reduced.
• The light will not come on.
• The safety devices are disabled.
Battery specifications:
• Endurance: The battery will last for 12 hours with a maximum of 1 to 3 operating cycles depending on the weight of the door.
• Recharging time: 48 hours.
• Service life prior to replacement: approx. three years.
To ensure optimum battery life, we recommend that the power to the motor is switched off and the door is operated for a number of cycles using
battery power (three times a year).
Forced operation mode (Fig. 18)
This function is used to move the door at any time (remote control lost, safety mechanism failure, etc.).
Remove the built-in lighting cover:
• Control door motion using the "
• Pressing and holding the " -" button will trigger closure.
• Pressing and holding the " +" button will trigger opening.
Operation after a power outage
After a power outage, the next time the door is moved, it must be opened completely. Always allow the door to open fully.
6
(Fig.17).
+" and "-" buttons.
(Fig.16),
16
17
18