Special Operation - SOMFY Dexxo Pro io Serie Manual De Instalación

Obstacle detection operation (Fig. 12 and 13)
The detection of an obstacle during door opening will stop the door and cause it to reopen slightly to clear the obstacle (Fig. 12).
When an obstacle is detected during the close cycle, the door will stop and then reopen (Fig. 13).
Once an obstacle has been detected, the light will flash for 30 seconds.
12
Light operation
The light will come on each time the motor drive unit is operated. The light will go out one minute after the door stops moving.
Repetitive use that causes the light to be continually on may result in a thermal cut out (this will automatically turn the light off).
Manual release cord operation (Fig. 14)
Dexxo Pro is fitted with a manual release mechanism so that you can move the door manually should a power failure occur, for example. The manual
release mechanism should be easily accessible and located no more than 1.80 metres above floor level.
[1]. Disengaging the motor drive mechanism
Pull on the manual release cord until the door drive mechanism is disengaged.
[2]. Manually moving the door
This is possible as long as the door drive mechanism is disengaged.
[3]. Reengaging the motor drive mechanism
Move the door manually until the drive mechanism comes to reengage itself into the transmission rail.
When disengaging the motor drive mechanism, use caution for a badly balanced door may cause sudden door movement that
may be dangerous.
Only use the cord to disengage the motor drive mechanism. Never use the cord to move the door manually.
Always reengage the motor drive mechanism before sending another command to the motor drive unit.

Special operation

Depending on the peripherals installed and the operating options set by your installer, the Dexxo Pro system may perform the following special
operations:
Using Telis, Situo or Composio (Fig. 15)
Safety photoelectric cell operation
An obstacle detected between the cells will prevent the door from closing.
The door will stop and then completely or partially reopen (depending on the setup selected during installation) when an obstacle is detected during
the close cycle.
The light will flash for 30 seconds during this process.
14
15
13
5