18_4.Cleaning The "Honeycomb" (Rif. 7); 18_5.Cleaning The Condenser (Rif. 16); 18_6.Cleaning The Water Collection Tank; 18_7.Cleaning Glass Parts - Arneg Kiruna Serie Manual De Instalación

18_4.Cleaning the "honeycomb" (Rif. 7)

The honeycomb must be cleaned every 6-8 months, based on sales conditions.

It can be cleaned using a vacuum cleaner or can be removed and washed using

soap and water.
It must be completely dry before being re-attached.

The honeycomb must be attached at the same angle.


18_5.Cleaning the condenser (Rif. 16)

The condenser must be cleaned every 30 days to remove any accumulated dust.
Use a hard-bristle (not metallic) brush or vacuum cleaner, taking care not to fold or

damage the condenser fins.

18_6.Cleaning the water collection tank

Clean the water collection tank periodically.
Removing the tank from the unit requires the assistance of a specialised technician.

18_7.Cleaning glass parts

DO NOT use hot water on cold glass surfaces, as the glass could shatter and

injure the operator.
DO NOT use rough or abrasive materials or metallic scrapers that could

scratch the glass surfaces
DO NOT use dirty cloths

Use a soft cloth with a neutral detergent or soap and lukewarm water (max

30°C).
Immediately remove all traces of water and detergent with a dry cloth in order

to avoid the formation of marks and to avoid the liquid reaching the gaskets,
frame, or the hinges of the glass doors.
To clean the sliding doors, (Rif. 18) simply:
Remove the doors by carefully lifting them upwards using both hands

Carefully lay them on a horizontal surface, taking care not to break or scratch them

Clean as specified for the cleaning of glass parts

Replace the doors


18_8.Cleaning stainless steel parts

Certain situations may lead to the build-up of rust on steel surfaces:
steel implements left on surfaces that are damp, lime scaled, not fully rinsed after

using chlorine- or ammonia-based detergents, encrusted with pieces of food, salt/
saline solutions, or dry residue from evaporated liquids.
Recent marks and rust:
clean with shampoo or neutral detergents using a sponge or cloth. When done,

remove any detergent residue, rinse well, and carefully dry the surfaces.
Old marks and rust:
use chemical substances for stainless steel that contain 25% nitric acid, or similar

substances.
Stubborn marks and rust:
sand or shine using a stainless steel brush. When complete, wash using

detergents and dry carefully. This may produce surface scratches due to abrasive
cleaning.
00 30/01/2012
Kiruna
English
33