Nice NDCC4001 Manual De Instrucciones página 60

Before using the automation for the first time, ask the installer to explain the origin of residual risks and devote a few minutes to reading this
manual. Keep the manual for reference when in doubt and pass it on to new owners of the automation.
CAUTION! - Your automation is a machine that performs your commands faithfully; negligent or improper use may make it
dangerous:
– Never activate automation controls if persons, animals or objects are present in the operating range.
– Never touch part of the automation while the door is moving!
- The photocells are not a safety device but only an auxiliary safety device. They are built with extremely reliable technology
but, in extreme situations, they may malfunction or even fail. In some cases the failure may not be immediately evident. For
these reasons, the following warnings must be considered while using the automation:
- transit is only permitted if the door is completely open and stationary
- NEVER transit while the door is closing!
- periodically check the correct operation of the photocells and safety systems.
1 - Children: an automation system guarantees a high level of safe-
ty, using its detection systems to prevent movement in the presence
of persons or objects, and ensuring constantly foreseeable and safe
activation. Nonetheless, it is advisable to ensure that children do
not play in the vicinity of the automation. To prevent any accidental
activation, keep the remote controls out of the reach of children: This
is not a toy!
2 - This product is not designed to be used by persons (including
children) whose physical, sensorial or mental capacities are reduced,
or with lack of experience or skill, unless suitable instructions regard-
ing use of the product have been provided by a person responsible
for safety or under supervision of the latter.
3 - Malfunctions: if the automation is seen to perform abnormally,
disconnect the electrical power supply from the system and manu-
ally release the gearmotor. Never attempt to perform repairs; contact
your local installer for assistance. In the meantime the system can
be used as a manual access point, after releasing the gearmotor as
described below in this document. In the event of breakage or a
power failure, while waiting for the installer or the electrical power
supply to return, the automation can still be used. Manually release
the gearmotor (see the motor instruction manual) and move the door
manually as required.
4 - Control with safety devices out of order: if the safety devices
present in the system malfunction, the door can be controlled in
"hold-to-run" mode as follows:
01. Send a command to activate door, with a transmitter or a key-
operated selector switch, etc. If it is in good working order, the
door will move properly, otherwise proceed as follows;
02. Activate and hold the command within three seconds;
03. After approx. 2 seconds, the door will carry out the requested
manoeuvre in "hold-to-run" mode; i.e., the door will continue
to move only as long as the command is held.
IMPORTANT! – If the safety devices are out of order, we rec-
ommend having them repaired by a qualified technical as
soon as possible.
5 - Even if you possess the skills, never modify the system or
programming and setting parameters of the automation: this
is the responsibility of the installer.
6 -Testing, periodic maintenance and any repairs must be docu-
mented by the person performing the operations and the relevant
documents must be kept by the system owner. The only operations
that can be performed by the user, and which we advise you to carry
out periodically, are to clean the photocell lenses and the automa-
tion. To prevent anyone from activating the door, release the auto-
mation system before proceeding with the operations (refer to the
motor instruction manual). Use a slightly damp cloth to clean.
7 - Disposal: At the end of the automation's lifetime, ensure that it is
disposed by qualified personnel and that the materials are recycled
or scrapped according to current local standards.
II
OPERATION MANUAL (to be delivered to the end user)