brennenstuhl ML DA 1206 DE 3993 Manual De Instrucciones página 13

cHARGING DEVIcES wITH A USB cHARGING cABLE
(E� G�SMARTPHONES):
only available on ML DA 2407 DE 3993!
Suitable for products with a charge current of max. 1000 mA.
Connect the device you wish to charge to the USB port (C) on the side
of the light using a USB cable. After charging, put the cap back on.
cHARGING THE BATTERy:
•
To ensure optimum functionality, we ensure completely
discharging the battery during initial use and then fully charging it.
•
The charging socket (D) is located under the end cap at the front of
the battery.
•
Use the battery level indicator (see description above) to determine
the battery level.
If all 4 LEDs are lit, the battery is fully charged.
•
Please note: If the light is switched on while charging with the
included power supply or car charger cable the battery will stop
charging.
•
The battery can also be charged separately from the lamp, see also
the "Replacing the battery" section.
•
If the light is not used for an extended period of time the battery
must be charged approximately every 3 months to ensure a long
battery lifespan.
•
After charging, make sure to close the charging port with the cap.
BATTERy REPLAcEMENT (II):
The battery (E) is quick and easy to replace. Simply unfasten the two
clips (F) at the top and bottom and remove the battery from below,
see drawing. This way, the battery can be charged while continuing to
work using a separately available replacement battery.
A-16P027_ML_DA_1206_DE_3993-ML_DA_2407_DE_3993_0489629_DinA6_171128.indd 13
Mobile Rechargeable SMD LED Light
D
13
28.11.17 09:35