Honda GC160 Manual Del Proprietário página 10

• Altering or defeating the governor linkage or speed-adjusting
mechanism to cause the engine to operate outside its design
parameters.
Problems That May Affect Emissions
If you are aware of any of the following symptoms, have your engine
inspected and repaired by your servicing dealer.
• Hard starting or stalling after starting.
• Rough idle.
• Misfiring or backfiring under load.
• Afterburning (backfiring).
• Black exhaust smoke or high fuel consumption.
Replacement Parts
The emission control systems on your Honda engine were designed,
built, and certified to conform with EPA, California, and Canadian
emission regulations. We recommend the use of Honda Genuine
parts whenever you have maintenance done. These original-design
replacement parts are manufactured to the same standards as the
original parts, so you can be confident of their performance. The use
of replacement parts that are not of the original design and quality
may impair the effectiveness of your emission control system.
A manufacturer of an aftermarket part assumes the responsibility that
the part will not adversely affect emission performance. The
manufacturer or rebuilder of the part must certify that use of the part
will not result in a failure of the engine to comply with emission
regulations.
Maintenance
Follow the maintenance schedule on
schedule is based on the assumption that your machine will be used
for its designed purpose. Sustained high-load or high-temperature
operation, or use in unusually wet or dusty conditions, will require
more frequent service.
Air Index
An Air Index Information hang tag/label is applied to engines certified
to an emission durability time period in accordance with the
requirements of the California Air Resources Board.
The bar graph is intended to provide you, our customer, the ability to
compare the emissions performance of available engines. The lower
the Air Index, the less pollution.
The durability description is intended to provide you with information
relating the engine's emission durability period. The descriptive term
indicates the useful life period for the engine's emission control
system. See your EMISSION CONTROL SYSTEM WARRANTY
(page 15) for additional information.
DESCRIPTIVE
TERM
Moderate 50 hours (0–80 cc inclusive)
125 hours (greater than 80 cc)
Intermediate 125 hours (0–80 cc inclusive)
250 hours (greater than 80 cc)
Extended 300 hours (0–80 cc inclusive)
500 hours (greater than 80 cc)
1000 hours (225 cc and greater)
10
page 6. Remember that this
APPLICABLE TO EMISSION
DURABILITY PERIOD
Specifications
GC160
Length x Width x Height
Dry weight
Engine type
Displacement
[Bore x Stroke]
Oil capacity
Fuel tank capacity
Cooling system
Ignition system
PTO shaft rotation
GC190
Length x Width x Height
Dry weight
Engine type
Displacement
[Bore x Stroke]
Oil capacity
Fuel tank capacity
Cooling system
Ignition system
PTO shaft rotation
Tuneup Specifications
ITEM
Spark plug gap
Valve clearance
(cold)
Other specifications
Quick Reference Information
ITEM
Fuel Type
Engine Oil Type
Carburetor Idle Speed
Spark plug Type
Maintenance Before each
use
First 5 hours
Subsequent
ENGLISH
13.3 x 14.7 x 13.0 in
(337 x 372.5 x 331 mm)
25 lb (11.5 kg)
4-stroke, overhead cam, single cylinder
9.8 cu-in (160 cm
[2.5 x 2.0 in (64 x 50 mm)]
20 oz (0.58 L)
0.48 gal (1.8 L)
Forced air
Transistorized magneto
Counterclockwise
13.6 x 14.7 x 13.0 in
(345 x 372.5 x 331 mm)
29 lb (13.2 kg)
4-stroke, overhead cam, single cylinder
11.4 cu-in (187 cm
[2.7 x 2.0 in (69 x 50 mm)]
20 oz (0.58 L)
0.48 gal (1.8 L)
Forced air
Transistorized magneto
Counterclockwise
SPECIFICATION MAINTENANCE
0.028 ~ 0.031 in
Refer to
(0.7 ~ 0.8 mm)
IN: 0.15 ± 0.04 mm See your authorized
EX: 0.20 ± 0.04 mm Honda dealer
No other adjustments needed.
DESCRIPTION
Unleaded gasoline with a pump octane
page 7
rating of 86 or higher (
SAE 10W-30, API SJ or later, for general
page 7
use. Refer to .
1,400 ± 150 rpm
BPR6ES (NGK)
Check engine oil level. Refer to
page 7
Check air filter. Refer to
Change engine oil. Refer to
Refer to the maintenance schedule on
page 6
.
3
)
3
)
page 8
.
).
page 7
.
.
page 7
.