Vetus DBPPJA Manual Del Propietário página 10

ENGLISH
1 7 Configuration of multiple control panels
Carry out the following actions on EACH panel in the order indi-
cated:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first press the "ON / OFF" button once to switch the
panel to the OFF position. (see 1.3)
Set up multiple control panels
You can configure four control panels (Group code A, B, C or D). Use
one group code per control panel.
1
10 seconds
1. Place the panel in configuration mode
• Push the joystick to the right, press and hold the "ON / OFF" but-
ton for 10 seconds.
2
1 x
2. Press the On/Off button
once.
4
OR
4. Move the joystick to the left or right to set the control panel code. The color of the LED indicates the control
panel group code.
10
020813.01
dididididididid ( . . . . . . )
6 seconds
(1) BLUE, ashing
3
didahdi ( . − . )
3. LED (1) flashes blue and you hear the signal, di-dah-di (. -.)
Now the panel is in configuration mode.
3
1
ON/OFF
4 seconds
During the first 6 seconds, LED (1) flashes blue and the buzzer will
continuously signal a didididididi ..... (. . . .). Keep pressing the "ON /
OFF" button. After 10 seconds the buzzer sounds the signal didididi-
dah (. . . - -).
1
1 BLUE, ashing
Group A BLUE, ashing
Group B RED, ashing
Group C BLUE and RED,
simultaneously ashing
Group D PURPLE, ashing
vetus® Owner's manual DBPPJA - Proportional panel for bow and stern thruster
2
1
2
4
dididididah ( . . . . − )
Con guration mode
i
mportant
If another combination of LEDs
is lit, first restore the factory
settings (see 1 5) and start chec-
king the thrust direction again
(see 1 4)
5
5. Press the On/Off button
once to confirm the set-
ting.
5
1 x