Hitachi NV 45AB2 Instrucciones Y Manual De Seguridad página 16

English
<NV45AB2(S)>
(1) Press the magazine stopper and open the
magazine cover.
Magazine Cover
(2) Adjust the position of the nail holder
according to the nail length.
The nail will not feed smoothly if the nail
holder is not correctly adjusted.
1 Turn the nail holder about 90 degrees
counterclockwise.
2 Move the nail holder up and down to
align the top of the nail holder with a
mark on the holder shaft in
accordance with the length of the
nails being used.
3 Turn the nail holder 90 degrees
clockwise until you hear "click".
For 1-1/4"
For 1-1/2" and 1-3/4"
Magazine Cover
Nail Holder
NOTE: Before loading nails in the magazine,
adjust the nail holder. If the magazine
cover is forcibly closed without
adjusting the nail holder correctly,
the nail holder may be damaged.
(3) Place the nail coil in the magazine.
Insert the first nail into the magazine
opening.
Magazine Stopper
For 7/8" and 1"
Mark
— 16 —
Magazine Opening
First Nail
Nails
(4) Close the magazine cover.
(5) Grip the nail guide and knob with finger.
Press the knob down and swing the nail
guide open.
Knob
Nail Guide
(6) 1 Uncoil enough nails to reach the
driving hole.
2 Insert the first nail into the driving
hole and the second nail between the
two pawls of the feeder.
3 Fit the nail heads in the guide slot.
Driving Hole
First Nail
2
Nail Guide
2
NOTE: Be careful not to deform the collated
wires and not to disengage the nails
with the guide surface.
Otherwise, the nail guide will not
close correctly.
Magazine
Guide Surface
Guide Slot
3
Feeder
Pawl