Nailer Operation; Methods Of Operation - Hitachi NV 45AB2 Instrucciones Y Manual De Seguridad

4 Pulling the nails to the right, swing the
nail guide closed.
(7) Lock the knob completely.
The Nailer is now ready to operate.

NAILER OPERATION

Read section titled "SAFETY"(pages 4 – 8).
Choice of triggering method is
important.
Please read
"METHODS OF OPERATION" below.
Never place your hands or feet closer
than 8 inches (200 mm) from firing
head when using.
Do not drive nails on the top of other
nails or with Nailer at too steep of an
angle; nails can ricochet and hurt
someone.
In order to avoid double fire or
unwanted ejection of a nail due to
bouncing of the Nailer.
1) do not push Nailer on workpiece
with strong force;
2) take Nailer away from workpiece
using recoil;
3) release trigger quickly when
performing trigger fire.
Do not drive nails into thin boards or
near corners and edges of workpiece.
Nails can be driven through or away
from workpiece and hit someone.
DANGER
Operators and others in
work area MUST wear
safety glasses with side
shields which conforms
to ANSI Z87.1
specifications.
WARNING
NEVER point tool at
yourself or others in
work area.
Keep fingers AWAY
from trigger when not
driving nails to avoid
accidental firing.
and understand
Never drive nails from both sides of a
wall at the same time. Nails can be
driven into and through the wall and
hit a person on the opposite side.
Never use Nailer which is defective or
operating abnormally.
Do not use Nailer as hammer.
Disconnect air hose from Nailer when:
1) it is not in use;
2) leaving work area;
3) moving it to another location; and
4) handing it to another person.
This Hitachi nailer has a STANDARD
CONTACT TRIP MECHANISM (Bounce Fire).
An OPTIONAL
MECHANISM kit (SINGLE SHOT) is available
as order part number 878226.
THE STANDARD
MECHANISM (Bounce Fire) is for use where
rapid fastener placement is desired and must
be operated in accordance with the following

"METHODS OF OPERATION".

NOTE:
Be careful that the final nail can be
dropped or driven at an irregular angle.
METHODS OF OPERATION
This Nailer is equipped with the push lever
and does not operate unless the push lever
is depressed (upward position).
There are two methods of operation to drive
nails with this Nailer.
They are:
1. Intermittent operation (Trigger fire):
2. Continuous operation (Push lever
fire):
(1) Intermittent operation (Trigger fire)
1 Position the nail outlet on the
workpiece with finger off the trigger.
2 Depress the push lever firmly until it
is completely depressed.
3 Pull the trigger to drive a nail.
4 Remove finger from the trigger.
To drive another nail, move the Nailer
along the workpiece and repeat this
procedure.
— 17 —
English
SEQUENTIAL TRIP
CONTACT TRIP