Publicidad
①
②
④
14
English
TO REMOVE/REPLACE CHEEKPAD
When first servicing the cheekpads, it is suggested that you do only one at a
time so that the other can be used as a reinstallation guide.
To remove the cheekpads, first undo chinstrap.
③
Lift up the neckroll tab ①, which is inserted under the black covering at the
forward lower edge of the pad assembly.
Pull the pad toward the rear of the helmet ②, then inward to release ③ and
slide it off the strap.
⑤
To take off fabric covering for washing, peel the covering off until all the fabric
is on the face side surface ④. Then draw the covering through the opening by
grasping the rectangular collar to pull through the pad ⑤.
NOTE: The cheekpad is equipped with a 5mmsurface foam layer. The layer is
⑥
removable to offer a bit more room if desired. Gently remove it from the pad.
Once removed this foam layer will not reattach securely ⑥.
To wash fabric coverings, put them into lukewarm water with small amount of
laundry soap or your own shampoo and wash gently by hand. Rinse well with
fresh water and wipe off with a soft cloth. Dry them in the shade at ambient
temperature. Do not machine wash or dry.
WARNING: Never use petrol, thinner, benzene or any other solvents.
Even mild and seemingly harmless chemicals can cause damage over
a short period of time.
Publicidad
Capítulos
